联系人:
申小姐
联系电话:
0755-83330991
0755-83047629
点击这里给我发消息
MSN:chipstech-int@hotmail.com 
首页 > 推广型号列表 > SN74ALVCH16543DGGR

SN74ALVCH16543DGGR

SN74ALVCH16543DGGR资料
SN74ALVCH16543DGGR
PDF Download
 
File Size : 116 KB
Manufacturer:TI
Description: 1. For a loaded output the measurements are observed after an RC filter consisting of a 1 kΩ resistor and a 0.01 µF capacitor to ground.  2. These limits define the range of operation for which the part will meet specification.  3. Within the supply range of 4.75 and 5.25 volts, the device operates as a fully calibrated linear accelerometer. Beyond these supply limits the device may   operate as a linear device but is not guaranteed to be in calibration.  4. The device can measure both + and C acceleration. With no input acceleration the output is at midsupply. For positive acceleration the output will increase   above VDD/2 and for negative acceleration the output will decrease below VDD/2.  5. The device is calibrated at 5g.  6. At clock frequency ≅70 kHz.  7. The digital input pin has an internal pull-down current source to prevent inadvertent self test initiation due to external board level leakages.  8. Time for the output to reach 90% of its final value after a self-test is initiated.  9. Time for amplifiers to recover after an acceleration signal causing them to saturate. 10. Preserves phase margin (60) to guarantee output amplifier stability. 11. A measure of the device's ability to reject an acceleration applied 90 from the true axis of sensitivity. 12. The Status pin output is not valid following power-up until at least one rising edge has been applied to the self-test pin. The Status pin is high whenever   the self-test input is high, as a means to check the connectivity of the self-test and Status pins in the application. 13. The Status pin output latches high if a Low Voltage Detection or Clock Frequency failure occurs, or the EPROM parity changes to odd. The Status pin can   be reset low if the self-test pin is pulsed with a high input for at least 100 µs, unless a fault condition continues to exist.
 
相关型号
◆ PJ-037A-SMT
◆ FZT591ATA
◆ 2-520081-2
◆ 2-520103-2
◆ G3VM21GR
◆ B40B-XADSS-N(LF)(SN)
◆ S301T-RO
◆ 172339-1
◆ V7-5F17D8-336
◆ 44441-2002
  1PCS 100PCS 1K 10K  
价 格  
 
 
型 号:SN74ALVCH16543DGGR
厂 家:TI
封 装:
批 号:07+
数 量:18547
说 明:原装正品
 
 
运  费:所有运费均有我司承担
所在地:深圳
新旧程度:
 
 
留言/订购
 
所需型号 厂家 封装 批号 数量*
 
留言
 
 
联系人/公司:
联系电话:
EMail:
验证码: * 验证码
 
 
 
 
联系我们:
联系人:申小姐
电 话:0755-83330991,0755-83047629
手 机:15811820920
QQ:2355514181
MSN:chipstech-int@hotmail.com
传 真:0755-61658118
EMail:sales@chipstech-int.com
公司地址: 深圳市福田区中航路鼎城国际1017
订购须知:

1. 所有我司提供的货物,均为原厂原装正品!

2. 我们的报价是不含税价格。含税需要增加相应的税点。

 

版权所有:芯科国际电子有限公司 技术支持:维库电子市场网   
访问统计:  建议使用分辨率:1024*768  友情链接      后台管理